CIRCUTOR DHB Series - Manual (Page 35)

35
Bit 15 Break of the supply
Bit 14 Re-set of the RTC clock.
3 38400 bit/s
4 57600 bit/s
5 115200 bit/s
Meter address. The write of the value 0 causes the
inerface switching off.
4033 Addr z/o 0...247
Transmission mode 4032 prot z/o 0...3
Update transmission parameters. Causes the appli-
cation of introduced RS-485 interface settings.
4034 sAvE z/o 0...1
Value
0 RTU 8N2
1 RTU 8E1
2 RTU 8O1
3 RTU 8N1
Description
Write of standard parameters 4035 SEt z/o 0...1
Value
0 without changes
1 set standard parameters
Description
Password for parameters 4036 SEc z/o 0...6000
Value
0 without password
... Entry in parameters preceded by a
request about the password
Description
Current time 4037 hour z/o 0...2359
This parameter occurs in the ggmm format,where:
gg - means hours,
mm – means minutes.
The introduction of a wrong hour will cause the set-
ting 23, however the introduction of wrong minutes
will generate the setting of the value 59.
Switch on/off the unit backlight 4038 unit z/o 0, 1
Value
0 Highlighting switched off
1 Highlighting switched on
Description
Reserved ... ... ... ...
Meter status. Describes the current state of the
meter. Successive bits present data of the event.
The bit set on 1 means, that the event took place.
Events can be only erased..
4048 Status1 z/o 0...65535
4039 z/o 0, 1 Extreme values’ deletion. Writing in “1” to the
register will cause the deletion of the minimum and
maximum values