CIRCUTOR DHB Series - Manual (Page 21)

21
bAud Baud rate of the RS485 interface
4.8 – 4800 bit/s
9.6 – 9600 bit/s
19.2 – 19200 bit/s
38.4 – 38400 bit/s
57.6 – 57600 bit/s
115.2 – 115200 bit/s
prot
Type of transmission frame of the
RS-485 interface.
r8n2
r8E1
r8o1
r8n1
Addr
Address in the MODBUS network.
The write of the value 0 switches
the interface off .
0...247
Table 6
SEr
Parameter
symbol
Description Range of changes
SEt
Write of manufacturer’s settings.
The setting of the value YES
causes the write of standard
parameters into the meter.
The value of manufacturer’s
parameters is presented in the
table 7.
no – do nothing.
YeS – causes the write of
manufacturer’s settings.
SEC
Introduction of a new password.
The introduction of the value 0
switched the password off.
0...60000
HOUR
Setting of the current time. The
introduction of a wrong time can-
cels the introduction of time.
The introduced value will not be
collected.
0.00...23.59
unIt Backlighting of the unit.
On – unit highlight switched
on.
Off – unit highlight switched
off.
tESt
Display test. The test consists of
a successive lighting up of digital
display segments. Alarm diodes
and unit highlighting diodes
should be lighted .
YeS – causes the test start.
The pressure of the
push-button ends the test.
no – do nothing.