CIRCUTOR QNA500 series - Manual (Page 107)

POWER QUALITY ANALYZER QNA500 8IO
QNA500 8IO Instruction manual 107 / 111
13.- TECHNICAL FEATURES
AUXILIARY POWER SUPPLY (M-BASE)
Power Supply Voltage: 90-300VAC / 100-300VDC
Frequency: 50...60 Hz.
Consumption : 11 VA (M-BASE)
5 VA (QNA500)
10 VA (M-8IO)
Working temperature: -10...55ºC
Altitude 2000 m
AUXILIARY BATTERY POWER SUPPLY (M-BASE)
Battery: Removable Ni-MH battery
Autonomy: 15 minutes of continuous operation (QNA500 8IO)
VOLTAGE MEASUREMENT (QNA500)
Measurement Circuit: 3 or 4-wire configuration
Measurement range : 0 to 500 VAC (phase-neutral),up to 866 VAC
(phase-phase)
Other voltages: Through VT (Voltage transformers)
Maximum voltage of the permanent measurement: 1500 VAC (phase-phase)
Isolation voltage:
1.2/50 uS (8/20 uS) 6 kV
Frequency: 42.5 to 69 Hz
Sampling frequency : 512 samples/cycle
CURRENT MEASUREMENT (QNA500)
Measurement range: 1 to 120% of I
n
for I
n
= 5A
Maximum current: 120% of I
n
(for I
n
=5 A, I
max
=6 A) permanent, 100A
t<1 s
Sampling frequency: 512 samples/cycle
EARTH LEAKAGE CURRENT MEASUREMENT (ID) (QNA500)
Measurement range: 0-3 A
Maximum current: 3 A
Sampling frequency: 64 samples/cycle
DIGITAL INPUTS (M-8IO)
Type Optocoupler
Working voltage: 12-18VDC
Isolation voltage: 5000V
Minimum width of the signal: 15 us
Consumption (per input) 2.5 mW
DIGITAL OUTPUTS (M-8IO)
Type: SOLID STATE RELAY (OPTO-MOSFET)
Working voltage: 250 V
Working current: 130 mA
Isolation voltage : 3750V (between digital outputs and any other part
of the equipment – galvanic isolation)