Connecting the power supply, Installation requirements for ce compliance, 11 swm24 hardware manual – Applied Motion SWM24IP-3EE User Manual
Page 11
Connecting the Power Supply
If you need information about choosing a power supply, please read “Choosing a Power Supply” located above in this
manual.
The SWM24 contains an internal fuse that connects to the power supply + terminal. This fuse is not user replaceable. If
you want to install a user serviceable fuse in your system install a 5 amp fast acting fuse in line with the + power supply
lead.
Be careful not to reverse the wires. Reverse connection may open the internal fuse on your driver and void
your warranty.
Installation Requirements for CE Compliance
In order to meet the EMC Directive of CE, a line filter must be installed between AC power and the DC power supply as
shown below.
EMI Filter
AC
Power
Input
LINE
LOAD
L
N
N
L
L
N
P/N:092.00823.00 (LCR)
4 31
2
POWER
DC POWER
SUPPLY
V-
V+
L
N
GND
SHIELD
11
SWM24 Hardware Manual
920-0068B
10/31/2013