D-Link DES-1012 User Manual

Page 33

10/100 Fast Ethernet Switch User’s Guide

Connecting the Switch

NOTE: To perform a factory reset, turn the device off. Power on the device

again and the factory settings should now be in effect.

Parameters in this screen are described in the following table.

Field

Description

PID

Displays the number of the currently selected port.

Displays the RX/TX status of the selected port, Enable or
Disable.

Link

Displays the current status of the link between the selected port
and the connected node. This can be Up or Down.

Displays the Auto Negotiation function status of the selected
port. This can be On or Off.

Spd

Displays the Port Speed associated with duplex mode. This
can be 10(10M/HDX), 20(10M/FCX), 100(100M/HDX), or 200
(100M/FDX).

Dupx

Displays the Duplex mode of the selected port. This can be Full

or Half Duplex mode. Full duplex transmissions effectively
double your bandwidth by carrying out transmission and receipt
of packets at the same time.

Each port in the 12-port NWay switch can be set for half duplex

or full duplex mode. You need to set the Duplex mode through
the Dip switch at the rear of the device. To set a port in full-
duplex mode, slide the corresponding switch up. To set it in half-
duplex mode, slide the corresponding switch down.

To make full duplex mode work properly, make sure both ends of

the link are configured to full duplex mode.

FCtrl

Displays Flow Control status of the selected port. This can be
On or Off.

Spd U

Displays User Set Port Speed. This can be 10 or 100Mbps.