D-Link DES-1012 - Manual (Page 26)

10/100 Fast Ethernet Switch User’s Guide
16
Connecting the Switch
Using a Straight Cable
When using straight cable, the connection can be made from the uplink
(MDI-II) port of the Switch to any port of the Hub (see figure 7).
Using a Crossover Cable
When using crossover cable, the connection can be made from any port of the
Switch to any port of the Hub (see figure 7).
Configuring the Port Speed &
Duplex Mode
After plugging the selected cable to a specific port, you can configure the
communication mode through console program (Auto Negotiation
Enable/disable, Port Speed) and Dip switch (Half/Full Duplex) on the rear
panel of the Switch:
1. If you have auto-negotiation disabled, an auto-sensing process is initiated
to select the speed, and the duplex mode will be set based on the Dip
switch setting.
2. If you have auto-negotiation enabled, but the partner does not support
auto-negotiation. Then an auto-sensing process is initiated to select the
speed, and the duplex mode is set based on the Dip switch setting.
3. If auto-negotiation is supported and enabled on both ends of the
connection and Dip switch is set to half-duplex (HDX), Dip switch
down, the auto-negotiation process is initiated to negotiate for one of the
following modes:
100Mbps/HDX
10Mbps/HDX
4. If auto-negotiation is supported and enabled on both ends of the
connection and Dip switch is set to full-duplex (FDX), Dip switch up,