D-Link DES-1012 - Manual (Page 17)

10/100 Fast Ethernet Switch User’s Guide
Unpacking and Setup
7
Figure 1B, Installing the Switch in an equipment rack
Power On
The Switch can be used with AC power sources 100 to 240 VAC, 50 to 60
Hz. The power switch is located at the rear of the unit adjacent to the AC
power connector and the system fan. To turn the Switch on, press the power
switch to the on or “1” position. The Switch’s power supply will adjust to the
local power source automatically and may be turned on without having any or
all LAN segment cables connected.
LED Indicators
After the switch is turned on, the LED indicators should respond as follows:
♦
The power LED indicator will be green.