Altera PCI Express Development Kit, Stratix II GX Edition Getting Started User Manual
Page 18
2–10
Getting Started User Guide
Altera Corporation
PCI Express Development Kit, Stratix II GX Edition
March 2008
Using the Demo Application and Example Design
1.
Install the PCI Express Development Kit, Stratix II GX Edition
CD-ROM.
2.
Open the Drivers directory, and double-click the install.bat file.
3.
After the install.bat file finishes copying files and installing the
drivers, shut down computer #1.
4.
Ensure that the Power slide switch is in the OFF position on the PCI
Express development board and insert the board into an x8 PCI
Express slot.
Finish Installing the Drivers and the Development Board, Run
the Demo Application
In this section, you finish installing the demo application drivers and the
PCI Express development board, then run the demo application.
1
If you want to download a programming file that is different
than the kit’s pre-installed example design file, refer to
Appendix A, Using the Parallel Flash Loader
1.
Start computer #1.
2.
When the Windows XP Found New Hardware Wizard appears
(
), click Next.
Figure 2–4. Found New Hardware Wizard Window