Inspect the board, Software requirements – Altera DSP Development Kit, Stratix & Stratix Professional Edition Getting Started User Manual
Page 15
Altera Corporation
Development Kit Version 1.3.0
2–3
December 2004
DSP Development Kit, Stratix & Stratix Professional Edition Getting Started Guide
Getting Started
■
SMA cable
■
RS-232 cable
■
Filtering reference design
Inspect the Board
Place the board on an anti-static surface and inspect it to ensure that it has
not been damaged during shipment. Verify that all components are on
the board and appear intact.
1
The Stratix EP1S25 DSP development board or the Stratix
EP1S80 DSP development board can be damaged without
proper anti-static handling.
1
For more information on the board components and their
locations on the development boards, see the Stratix EP1S25
Development Board Data Sheet or the Stratix EP1S80 Development
Board Data Sheet. These documents are located at:
●
For the DSP Development Kit, Stratix Edition Version 1.3.0
CD-ROM (Stratix EP1S25 Development Board Data Sheet):
<install_ path>/stratix_dsp_kit-v<version>/Docs/
or
●
For the DSP Development Kit, Stratix Professional Edition Version
1.3.0 CD-ROM (Stratix EP1S80 Development Board Data Sheet):
<install_ path>/stratix_dsp_pro_kit-v<version>/Docs/
Software Requirements
You should install the following software before you begin developing
designs for the kit:
■
The Quartus II software starting with version 4.2. See
Quartus II Software” on page 2–4
■
The software on the DSP Development Kit, Stratix Edition Version 1.3.0
CD-ROM or the DSP Development Kit, Stratix Professional Edition
Version 1.3.0 CD-ROM. See