Pilz PSSnet SHL 8T MRP - Manual (Page 21)

Ring Redundancy
PSSnet SHL - Redundancy Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
2.2 Example of MRP-Ring
21
Display in “Operation” field:
forwarding: this port is switched on and has a link.
blocked: this port is blocked and has a link.
disabled: this port is switched off
not connected: this port has no link.
Figure 6: Ring Redundancy dialog
In the “Ring Recovery” frame, select 200ms.
Note: If selecting 200ms for the ring recovery does not provide the ring
stability necessary to meet the requirements of your network, you select
500ms.
Note: Settings in the “Ring Recovery” frame are only effective for
devices that you have configured as ring managers.
Under “Configuration Redundancy Manager”, activate the advanced
mode.
Activate the ring manager for this device. Do not activate the ring
manager for any other device in the MRP-Ring.
Leave the VLAN ID as 0 in the VLAN field.
Switch the operation of the MRP-Ring on.
Click on “Set” to temporarily save the entry in the configuration.