Pilz PSSnet SHL 8T MRP - Manual (Page 15)

Ring Redundancy
PSSnet SHL - Redundancy Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
2.1 Example of HIPER-Ring
15
2.1.1 Setting up and configuring the HIPER-Ring
Set up the network to meet your requirements.
You configure all 6 ports so that the transmission speed and the duplex
settings of the lines correspond to the following table:
Bit rate 100 Mbit/s 1000 Mbit/s
Autonegotiation
(automatic configuration) off on
Port on on
Duplex Full –
Table 2: Port settings for ring ports
Select the Redundancy:Ring Redundancy dialog.
Under “Version”, select HIPER-Ring.
Define the desired ring ports 1 and 2 by making the corresponding
entries in the module and port fields. If it is not possible to enter a
module, then there is only one module in the device that is taken
over as a default.