Volvo 2013 XC70 - Manual (Page 95)

03 Your driving environment
Lighting
03
* Option/accessory, for more information, see Introduction. 93
Headlight switch with AUTO and lever
High beam flash
Toggle between high and low beams
Position Description
Daytime running lights/high
beams/high beam flash
Parking lights
Position Description
Low beams/high beams/high
beam flash
"Tunnel detection"* will acti-
vate the low beams in poor
lighting conditions
The "Active high beam"* func-
tion can be used
High beam flash
Low beams/high beams/high
beam flash
Volvo recommends using the position
whenever weather conditions allow the use of
the "Active high beam"* function (see
page 94).
High beam flash
Move the lever toward the steering wheel to
position 1. The high beams come on until the
lever is released.
High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward the
steering wheel to position 2 to toggle
between high and low beams (this also
applies on models equipped with the
optional Active Bending Lights).
> The symbol
illuminates in the
instrument panel to indicate that the
high beams are on.
Low beams
When the engine is started, the low beams are
activated automatically (daytime running lights)
if the headlight control is in position 0 or
.
Daytime running lights can be deactivated in
the MY CAR menu system under
Settings
Car settings Light settings Daytime
running lights .
However, please be aware that these lights
may not be deactivated in Canada.
NOTE
• The use of daytime running lights is
mandatory in Canada.
• Continuous high beams cannot be acti-
vated when the headlight switch is in
position
. High beam flash will
function in this position.