Volvo 2013 XC70 - Manual (Page 318)

08 Wheels and tires
Changing a wheel
08
316
WARNING
• The jack must correctly engage the jack
attachment.
• Be sure the jack is on a firm, level, non-
slippery surface.
• Never allow any part of your body to be
extended under a vehicle supported by
a jack.
• Use the jack intended for the vehicle
when changing a tire. For any other job,
use stands to support the vehicle.
• Apply the parking brake and put the
gear selector in the Park (P) position.
• Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
• The jack should be kept well-greased
and clean, and should not be damaged.
• No objects should be placed between
the base of jack and the ground, or
between the jack and the attachment
bar on the vehicle.
NOTE
The jack provided with your vehicle is
intended to be used only in temporary sit-
uations such as changing wheels in the
event of a flat tire. Only the jack that came
with your particular model should be used
to lift the vehicle. If the vehicle needs to be
lifted more frequently or for a prolonged
period, using a garage jack or hoist is rec-
ommended. Always follow this device’s
instructions for use.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten hand-
tight. Using the lug wrench, tighten cross-
wise until all nuts are snug.
4. Lower the vehicle to the ground and alter-
nately tighten the bolts crosswise to
103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable).
The opening in the wheel cover for the tire's
inflation valve must be positioned over the
valve.