DirecTV DSR 660 - Manual (Page 37)

37
Troubleshooting TV2
1. Make sure TV2 power is on.The TV2 power indicator on the front panel of the receiver
should be on.
2. Check TV2 connections.
3 Check the DIRECTV
® Multi-Room Receiver output settings:
a. check the selected frequency type (i.e.Terrestrial or Cable) is correct (see page29).
b. check the modulator frequency is set on the appropriate channel (see page29).
1. Make sure that the TV2 volume is not set to mute.
2. Check TV2 connections.
1. Make sure the batteries are inserted correctly (see page 13) and are not dead.
2. Be sure you are within operating range of the TV2 remote control attachment.
3. Make sure no objects obstruct the line of sight between the remote and the TV2 remote
control attachment.
4. The TV2 remote control attachment LED is off:
a. check the TV2 remote control attachment connections.
b. check TV2 remote control attachment is enabled.
5. The TV2 remote control attachment LED is on:
a. check you are using the TV2 remote control.
b. if the remote control ID was changed so the DIRECTV Receiver and the remote no longer
communicate, change the ID number back to the previous ID number (see page 28).
This section is specific to TV2.
No picture
No sound
Remote does not
work
SX660-2312 23/12/03 18:01 Page 37