DirecTV DSR 660 - Manual (Page 33)

Main Menu (cont’d)
33
Setup: Output Channel TV2
This menu is used to set the output signal sent to TV2.
1. Press MENU.
2. Press
▼ to select “Setup” and press OK.
3. Press
▼ to select “Output Channel TV2” and press OK.
To enable remote control attachment to TV2:
4. Select “TV2 Remote Attachment” and press OK.
5. Use the
▲▼ buttons to choose “Enable Remote
Attachement” or “Disable Remote Attachement” and press
OK to confirm and exit the screen.
Note: Enabling remote control attachment will send voltage to your
TV2 remote control attachment. If there is no remote control
attachment, serious damage may occur to your TV set.
To set the TV2 modulator frequency type:
4. Select “Frequency Type” and press OK.
5. Use the
▲▼ buttons to choose between Terrestrial off-air
reception or Cable (CATV) reception. Press OK to confirm
and exit the screen.
To set the TV2 modulator frequency:
6. Select “Modulator Frequency” and press OK.
7. Use the
▲▼ buttons to choose a frequency and press OK to
confirm and exit the screen.
Note: The modulator frequency should not be modified from TV2. It
is preferable to modify it from TV1.
To save the changes:
8. Use the “Save changes” button to access the “Change
Confirmation” screen and press “Confirm” in order for the set-
tings to take effect or “Cancel” to cancel the changes.
Note: If you lose video on TV2, check the “Modulator Frequency”
screen on TV1 to make sure your modulator frequency and mod-
ulator frequency type match your TV2 setup.
“Output Channel TV2” menu
“Frequency Type” menu option
“Modulator Frequency” menu options
SX660-2312 23/12/03 18:01 Page 33