DirecTV DSR 660 - Manual (Page 18)

Setup Wizard
18
If your equipment has been professionally installed, skip this first
time setup section and go to page 19.
After the DIRECTV ® Multi-Room Receiver has been connected to
your components, it is time to turn the DIRECTV Receiver on.
1. Connect your receiver to the AC output.
2. The Select preferred language menu appears.
3. Use the
▲▼ buttons to select your preferred language of the on
screen menus and guide and press OK.
4. When the Welcome screen displays, press the OK button on the
remote control to start the Setup Wizard.The Setup Wizard is a
first time setup that automatically steps you through the installa-
tion process.This screen will ONLY appear the very first time
your DIRECTV Receiver is turned on.
a. Enter the ZIP code.
Note: The ZIP code is critical to point your dish accurately
(refer to page 32).
b. Configure the dish (refer to page 32).
c. Point the dish (refer to page 32).
d. Test the System (refer to page 33).
5. After you have installed your DIRECTV System, you should
contact DIRECTV to order DIRECTV ® programming at
1-800-531-5000.
Important note
Some of the menu and/or option screens, such as Setup, Parental
Controls, Editing a favorite list, or Messages, cannot be accessed
simultaneously from TV1 and TV2. If you try and access one while
it is being used at the other TV, a warning will be displayed.
Messages Access Conflict screen
SX660-2312 23/12/03 18:00 Page 18