DirecTV DSR 660 - Manual (Page 28)

28
Main Menu (cont’d)
Preferences: Banner Duration
Banner durations define how long the banner remains on the
screen after you press INFO. Options are 5, 10, 15, or 20
seconds.The default value is 10 seconds.
To select the banner duration:
1. Press MENU.
2. Press
▼ to select “Preferences” and press OK.
3. Press
▼ to select “Banner Duration” and press OK.
4. Use the
▲▼ buttons to choose from the options.
5. Once you have made your selection, press OK.
Preferences: Set Favorite Channels
Refer to Enhanced User Features section, page 21.
Preferences: translucency
You can adjust the background translucency to make it easier for
you to read the text displayed on the screen.
To set the background translucency:
1. Press MENU.
2. Press
▼ to select “Preferences” and press OK.
3. Press
▼ to select “Translucency” and press OK.
4. Select one of the four translucency levels and press OK.
Preferences: Remote Control ID
You can control the DIRECTV ® Multi-Room Receiver and the
TV2 remote control attachment independently by assigning a
separate ID number to each remote control.
To change the ID number of the remote control:
1. Press MENU.
2. Press
▼ to select “Preferences” and press OK.
3. Press
▼ to select “Remote Control ID” and press OK.
4. The only option available is the alternate ID. Select and press OK.
5. Press and hold down the SAT and MUTE buttons on the
remote until the SAT light stays on.
6. To set the ID number to 1, enter “111” or to set the ID to 0,
enter “000”.The SAT button will blink twice to confirm the
entry.
7. Point the remote at the Receiver and press OK to complete
the process.
Note: It is important at the end of the procedure to point the
remote at the DIRECTV Receiver and press OK. Otherwise, the
remote control will change its ID but the Receiver will not and
communication will be lost between the two.
“Banner Duration” menu options
“Translucency” menu options
“Remote Control ID” screen
SX660-2312 23/12/03 18:01 Page 28