Woodhaven 8531: 3" Hinge Routing Jig, 5/8 Radius" User Manual

8531 hinge jig, Please read carefully, Parts list

BEFORE BEGINNING

Identify and verify that you have all the parts listed.

Read the instructions at least once before beginning.

ASSEMBLY

Cut a wood fence approximately 3/4" thick, 1-1/4" wide

and 12" long to mount the Hinge Jig to. If you want, you can
make the wood fence longer to mount more then one Hinge Jig
to it so you can cut two or more hinge mortises at a time.

Drill two 1/8" pilot holes in the edge of the wood fence 6-3/8"

on center. Attach the wood fence to the underside of the jig using the
3/16" Washers (WS003) and 3/4" Screws (STP001). See fig. 1, 2 & 3.

Attach the 1/4" Spacers (BUSH002) to the underside

of the jig using the 1/2" Thumb Screws (5503). See fig.
1, 2 & 3. The other two holes in the jig are for storing
the thumb screws & spacers when not needed.

Parts List:

Part listed below is not shown in the hardware

drawings. Refer to photos in the instructions:

Part Description

Quantity

8531

3" Hinge Jig . . . . . . . . . . . . . . . . . . . . . . . . . . 1

In addition, please identify and verify that you have all of

the parts shown below prior to assembly.

Part# Description Qty.
WS003 1”

Washer

Part# Description Qty.
BUSH002 1/4" Spacer

Part# Description Qty.
STP001 3/4"

Screw

Part# Description Qty.
5503 Thumb

Screw

3-1/8" opening

8531 Hinge Jig

Attach spacers here

Jig

Spacer

Thumb

Screw

Door

Wood

Fence

Picture may not be

of your Hinge Jig.

8531

Hinge Jig

Please Read Carefully!