Woodhaven 7285: Bandsaw Fence Circle Jig - Manual (Page 4)

USING THE CIRCLE JIG
Make sure the Circle Jig Base is against the miter lock
when making your setups. Set the desired cutting radius
(The raduis is half the diameter.) by measuring from the
band saw blade to the center of the Cicrle Pin. Adjust the
position of the Circle Pin in or out as necessary in the One
Track and tighten the set screw with the 1/8" wrench.
Drill a 1/8" pilot hole 1/4" deep in the underside
of your workpiece. Pivot the Circle Jig Base away from
the miter lock and set the pilot hole in the workpiece on
the Circle Pin. The workpiece should be able to turn on
the Circle Pin and not contact the band saw blade.
Turn the band saw on and pivot the Circle Jig Base
against the miter lock, holding the workpiece from turning
as you do so. Maintaining a light pressure of the Circle Jig
Base against the miter lock, start turning the workpiece
slowly on the Circle Pin until the circle is cut. Turn the
band saw off and remove the part. See fig. 8-10.
©Copyright WOODHAVEN INC. 4/14/06
(800) 344-6657 or WWW.WOODHAVEN.COM
3
8
9
10