Woodhaven 7282: Large Bandsaw Fence - Manual (Page 3)

Get the pair of guides (7280B), which are mirror images of
each other, and install 1" bolt (HB030) thru the hole shown on
each guide. Install a washer (WB002), 1/8" spacer (BUSH001)
and knob (5860) on the end of each bolt. Install a 1/4" spacer
(BUSH525) on two of the knobs (5863). Starting from the
smooth side of the guide, insert the stud of the knob thru the
hole shown in the guide and start an oval nut (5760B) on the
end of the stud. Insert a thumb screw (5503) into the threaded
hole shown in the guide. This is used for squaring the fence
later and may get moved to the opposite hole in the guide, or
possibly not used at all. See fig. 5.
Attach the guides to the 36" double tracks. The rib of
the guide and the oval nut will fit into the T-slot of the track.
Position the guides on the tracks an equal distance from the end
of each track and tighten the knobs. See fig. 6.
Slide the 32" Ultra Track (4432) onto the bolt heads on top
of the guides until evenly spaced from each end and tighten the
knobs underneath. See fig. 7.
2
5 6
3
4
7/16”
7
Front Guide:
Side View
Front Guide:
Bottom View
Rear
Guide:
Top View
Front Guide
Rear Guide
Front Guide