Woodhaven 5302: 5-1/2" Plate Kit - Manual (Page 2)

3
USING THE PLATE
The Plate Kits are designed to be used with the 5380K MDF Door Kit. With a 1/2" diameter bit, the 5301
Plate Kit will cut 2-1/4" from the edge of the Ultra Track or Template and the 5302 Plate Kit will cut 2-1/2"
from the same edge. By using the 56100-56450 Stile Bits we offer with the 5301 Plate kit, and the 57100-5725-
Panel bits we offer with the 5302 Plate Kit, you can cut a true raised panel profile in any panel. You can also
use just the 5301 or 5302 Plate Kit with a Stile bit, Panel bit, round nose or V-groove bit by themselves.
Keep the base of the Plate Kit firmly against the Ultra
Track or Template while cutting and move in a
clockwise direction around the interior of the
5380K MDF Door Kit. Practice on a scrap
panel first before attempting any
cuts in your finished panels.
©Copyright WOODHAVEN INC. 11/10/10
(800) 344-6657 or WOODHAVEN.COM
4
ASSEMBLY
Install the 1/4" center
pin (PIN450) in your routers
1/4" collet and tighten. With
the router setting on a work
bench and the router plate
facing up, set the 5-1/2" base
(5302B) on the router plate.
Set the recessed portion
of the center disk (5300C) in
the opening of the base as you
slide it onto the center pin.
Orient the base so the router
controls and handles will
be in a comfortable location
for you. Install a washer
(WS002) on each of the 3/4"
bolts (HB020). Insert the 3/4"
bolts thru the two slots in the
base and start them by hand
into the threaded holes in the
router plate. Make sure the
recessed edge of the center
disk is in the bit opening of
the base and held against it,
then tighten the bolts with
a 7/16" socket. Remove the
center disk and center pin.