Woodhaven 1435-6-7: EZ Lifts User Manual

Page 2

INSTALL ROUTER MOTOR

Install the socket (1435S) on the square drive of the crank

handle (1435HX). Place the socket/crank handle on the nut of
the motor tightening bolt and loosen it (turn counter-clockwise)
3-4 turns. See fig. 1.

Get your router motor and slip it into the motor block of

the EZ Lift so it projects out the plate side of the motor block
3/4" to 1". You may have more than one choice as to which way
to install the router motor, so select the position that places the
cord and switch in the best possible position for you. The router
motor can be adjusted for height in the motor block later (coarse
adjustment) to better suit above-the-table bit changes, etc., but
ALWAYS make sure the router motor is fully inserted in the
motor block! See fig. 2.

Place the socket/crank handle on the nut of the motor

tightening bolt and tighten (turn clockwise) the router motor in
the motor block. DO NOT OVERTIGHTEN! See fig. 1.

To remove the router, use the crank handle to loosen the

motor tightening bolt 2-3 turns, then tap on the end of the nut
with the socket (or a block of wood) until the router is free.

This same socket/crank handle is also used to adjust the

router/bit height on the EZ Lift. Never use a power tool con-
nected to the socket!

USING THE 1436A OR 1437A ADAPTER

If using an adapter (1436A or 1437A) to reduce the open-

ing in the 1436 or 1437 EZ Lift for use with a 3-1/2" motor,
make sure the slot in the adapter is facing the height adjustment
mechanism of the EZ Lift before tightening. See fig. 4.

Motor
tightening
bolt

Slot in the
adapter
must face
the height
adjustment
mechanism

ALWAYS make sure the router motor is
fully inserted in the motor block!