Woodhaven 1440-1441: Digital Readout Kit for EZ Lift User Manual
Page 2
IF YOU PURCHASED THE 1435-1437 AFTER 10/1/10
Attach the two brackets (1440D) to the Ultra Track using
an offset oval nut (5765B) and a 5/8" screw (5775B). Tighten
the brackets in position, one at the top of the Ultra Track and
one near the bottom of the Ultra Track and resting on the short
Double Track. Position the offset oval nut of the top bracket so
it does not protrude out the top of the Ultra Track. See fig. 3.
Get the Digital Readout (1445) and read thru the
iGAGING DigiMAG Remote Readout instructions to
familiarize yourself with its parts list. The Slider Sensor Unit
(3) comes pre-installed on the Digital Scale Beam (4). Press the
Slider Sensor Unit in the notch of the Glide (1440A), moving
the Digital Scale Beam in the Slider Sensor Unit as needed.
The Connection Cable (2) of the Slider Sensor Unit should
be sticking out towards the back of the EZ Lift as shown. We
have modified the Digital Scale Beam to fit our EZ Lift. Attach
the Digital Scale Beam to the two brackets (1440D) using a
nylon washer (WN002) and a 1/2" screw (5770B). See fig. 4.
The Digital Display Unit (1) can be mounted on any
magnetic surface using the magnets in the back of it. We also
supply a Display Mount (1440C) that has the Stand Base for
Display Unit (8) pre-attached to it. This can attach to the top
T-slot of our Router Fence using the two 3/4" bolts (HB020) and
knobs (5521), or be clamped to your router table. See fig. 5 & 6.
USING THE DIGITAL READOUT
You will have extra hardware left over (5, 6, 7 & 9) from
the iGAGING parts list. This is the manufacturers mounting
hardware that we don't use. Follow the iGAGING instructions
regarding the Display Functions. Install the batteries in the back
of the Digital Display Unit (10 - rear view) to begin using it.
©Copyright WOODHAVEN INC. 10/15/10
(800) 344-6657 or www.woodhaven.com
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
Attach 1440D Brackets
to Ultra Track in two
locations.
Attach Slider Sensor
Unit/Digital Scale
Beam to 1440D
Brackets.
Connection Cable
on Slider Sensor
Unit should stick out
towards the back of the
EZ Lift.
3
5
6
4