Woodhaven 788XL: Dado Jig - Manual (Page 8)

17. OTHER USES
By adjusting the Adjustable Track so the Router Plate/
Plate Guide can't move side to side between the Adjustable
and Stationary Track, you can use the jig for making
flutes, sliding dovetails and other long straight cuts.
To cut angled dadoes, install an angled sub-fence to the
clamp pads of the jig. To do this, drill a hole in each pad
and attach the sub-fence to them with wood screws, after
all other adjustments have been made. You'll have to clamp
the stock and the jig to the workbench separately. Note
that an angled sub-fence will limit the width of stock that
can be dadoed. You'll want to slide the edge fence as close
to the narrow (pointed) end of the sub-fence to maximize
the stock width that can be dadoed. See fig. 17 & 18
18. DADO JIG ACCESSORIES
The Front Track of the Dado Jig can be extended on
one or both ends using the Fence Kit (4424XL - 24" shown,
4436XL - 36" or 4448XL - 48"). The Fence Kit allows you
to attach Flip Stops to the track to make cutting multiple
dadoes easier. Flip Stops (789S) and flip stop Micro
Adjusters (4523) are available separately. See fig. 19 & 20
The
Toggle Clamp Kit (789T) attaches to the Front Track
(top & bottom) and allows you to clamp your stock to the Dado
Jig. It requires that your stock overhang your workbench a
minimum of 2". See fig. 21
©Copyright WOODHAVEN INC. 10/02/07
(800) 344-6657 or WWW.WOODHAVEN.COM
7
17
18
19
20
4424XL with two
789S stops
4424XL
789S
789S with 4523
Micro Adjuster