Dell 1000 - Manual (Page 36)

36
Using PC Cards
www
.dell.com | support.dell.com
2 Slide the card into the slot until the card is completely seated in its connector.
If you encounter too much resistance, do not force the card. Check the card orientation and
try again.
The computer recognizes most PC Cards and automatically loads the appropriate device driver.
If the configuration program tells you to load the manufacturer's drivers, use the floppy disk or CD
that came with the PC Card.
Removing a PC Card
NOTICE:
Before you remove a PC Card from the computer, click the icon in the taskbar to select a
card and stop it from functioning before you remove it from the computer. If you do not stop the card in
the configuration utility, you could lose data. Do not attempt to eject a card by pulling its cable, if one
is attached.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
Press the latch and remove the card.
PC Card PC Card
release latch