Vortech H3 I-5 Hummer - 2006-2008 - Manual (Page 17)

P/N: 4GN020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
20OCT08 v2.0(4GNv2.0)
9
Fig. 6-e
F. Place the power steering reservoir adapter fit-
ting on the port previously connected to the
pump. (See Fig. 6-e, 6-f.)
G. Mount the factory power steering reservoir to
the supercharger mounting plate using the
supplied 1/4-20 x 1" screws, washers and
Nyloc nuts. (See Figs. 6-d, 6-f.)
H. Secure the adapter using the retaining brack-
et and three 1/4-20 x 1" screws, washers and
nyloc nuts provided. (See Figs. 6-e, 6-f.)
I. Connect the Ø1/2" power steering hose to the
adapter fitting on the reservoir. Route the
hose through the supercharger mounting
bracket and down to the power steering
pump and attach. Secure the previously
installed hose using the #6 hose clamps pro-
vided. (See Fig. 6-e, 6-f.)
J. Install the 3/8" hose union into the hose that
was previously connected to the bottom of
the power steering reservoir and secure using
the factory hose clamp. (See Fig. 6-e.)
K. Connect the supplied length of 3/8" power
steering hose to the previously installed
union. Secure using the clamp provided.
(See Fig. 6-e)
L. Connect the open end of the previously
installed 3/8" hose to the port on the bottom
of the power steering reservoir and secure
using the remaining hose clamp provided.
(See Figs. 6-e.)
NOTE: All hoses should be free of any kinks or
pinches and be secured away from hot or
moving parts.
3/8"
UNION
1/2" P/S
HOSE
Fig. 6-f
6. MOUNTING BRACkET AND SUPERChARGER INSTALLATION , CONT.