Vortech H3 I-5 Hummer - 2006-2008 - Manual (Page 15)

P/N: 4GN020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
20OCT08 v2.0(4GNv2.0)
7
A. Locate the S/C mounting bracket assembly
(4GN111-044).
B. Loosely install the three M8-1.25 x 45mm
hex-head screws provided through the super-
charger mounting bracket and power steering
mounting bracket into the power steering
pump. (See Fig. 6-a.)
C. Re-connect the power steering pressure line
to the pump and secure.
D. Using the 6mm nut and 1/4-20 x 1" hardware
provided, locate the supercharger bracket
support as shown. Do not tighten the hard-
ware (See Figs. 6-b, 6-c.)
E. Evenly tighten the previously installed hard-
ware, insuring that the bracket supports but
does not pull or change the location of the
S/C bracket. Tighten the suppoort hardware
at this time.
6. MOUNTING BRACkET AND SUPERChARGER INSTALLATION
Fig. 6-a
NOTE: For the following section, refer to Fig. 6d, on
page 8, for screw and spacer location. Do not
tighten until all hardware is in place.
Caution: Do not over tighten.
(3) M8-1.25 x 45mm
SCREWS (NO WASHERS)
Fig. 6-b
Fig. 6-c