Vortech H3 I-5 Hummer - 2006-2008 - Manual (Page 10)

P/N: 4GN020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
20OCT08 v2.0(4GNv2.0)
2
Fig. 1-d
Fig. 1-e
Fig. 1-f
J. Using a 13mm socket remove the three
screws retaining the power steering pump to
the pump bracket. Set the pump on a clean
flat surface. (See Figs. 1-d, 1-e.)
K. Remove the two reservoir retaining clips hold-
ing the plastic reservoir to the power steering
pump. Set the clips aside and detach the res-
ervoir from the pump. Be careful not to lose
the rubber O-ring on the reservoir. Set the
reservoir with O-ring aside. (See Fig. 1-e.)
L. 2007 Models Only: Locate the stud on the
passenger’s side inner fender (previously
retained the lower portion of the factory air
box). Cut the stud off flush with the inner
fender surface, using an appropriate cutter.
(See Fig. 1-f.)
NOTE: It is a good idea to dress (either with paint or
other means) any bare metal that may have
been exposed as a result of the cutting pro-
cess.
AIR BOX STUD
PASSENGER’S SIDE
INNER PENDER
POWER STEERING
RESERVOIR
CLIPS
1. PREPARATION/REMOVAL, cont’d