Denon D-M51DVS - Manual (Page 52)

ENGLISH
52
[2] 2-channel mode settings
• When 2-channel signals are input, one of two playback modes can be selected and set according to the 2-channel mode setting, Virtual 1 or
Virtual 2. (The Virtual 1 mode is set by factory default.)
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic II Cinema processing.
Virtual 1 : 2-channel sources are played in virtual surround using Dolby Pro Logic processing.
BAND
PHONES
VOLUME
ON / STANDBY
DVD SURROUND RECEIVER ADV-M51
TONE / SDB
FUNCTION
MENU / SET
+ -
SURROUND / SELECT PUSH - PARAM.
1,2,3
RC-936
A / V
3
STATUS
RETURN
ANGLE AUDIO SUB TITLE
SETUP TONE /SDB
FUNCTION SURROUND INPUT MODE TEST TONE
DVD
ENTER
MUTING
0
DISPLAY MENU TOP MENU
SYSTEM MD
CDR TAPE
TUNER TV / VCR
SURROUND PARAMETER CH SELECT
- + VCR CH
IN/SURR.
IN/SURR.
DVD
9 8
2 1
7 6
+
-
1
3
2
NOTES:
• The 2-channel mode cannot be set when Dolby Digital or DTS
5.1-channel signals.
• The 2-channel mode is set and stored in the memory individually
for the different functions.
1 Set the surround mode to “DOLBY VIRTUAL SPEAKER”
(“DOLBY VS”).
• The normal display reappears after the surround mode is
displayed.
SURROUND / SELECT
PUSH - PARAM. SURROUND
Main unit Remote control unit
2
Press the SURROUND PARAMETER
button and select the 2-channel
mode.
SURROUND / SELECT
PUSH - PARAM.
Main unit
2 V I R T U A L 1
This can be selected if there is no
digital input signal, if the digital
input is a PCM or Dolby Digital 2-
channel signal and if the input is
analog.
SURROUND
PARAMETER
Remote control unit
3 Turn the SURROUND/SELECT control on the main unit or use
the
0 and 1 cursor buttons on the remote control unit to
select the desired 2-channel mode.
SURROUND / SELECT
PUSH - PARAM.
Main unit Remote control unit
VIRTUAL 1 VIRTUAL 2
Once the surround parameters have been set, stop operating the
buttons. After several seconds, the normal display reappears and
the settings are automatically entered