Turning Technologies RemotePoll - Manual (Page 10)

RemotePoll 10
CONFIGURING REMOTEPOLL ON REMOTE
COMPUTERS
RemotePoll must be configured in order to establish communication between the application and TurningPoint Cloud,
TurningPoint 5, TurningPoint 2008 or TurningPoint AnyWhere. This chapter provides the necessary steps to successfully
configure RemotePoll with each polling application.
ResponseWare
RemotePoll uses a ResponseWare connection to communicate all responses received from the audience back to the
presenter.
WARNING
If using ResponseWare to connect to RemotePoll sites, the presenter must use a receiver and the
participants must use clickers to submit responses. Participants cannot use ResponseWare to submit
responses.
Setting up a ResponseWare Connection
Prerequisites
A Session ID from the host computer is required to connect via a ResponseWare web connection.
1 Open RemotePoll.
2 Click the Status tab.
3 Below Connection Type, select ResponseWare.
4 Below Server URL, click Change.
5 Enter http://remotepoll.turningtechnologies.com in the Server URL field.
6 Click Change to save the changes.
7 Enter the Session ID or Reserved Session ID in the Session ID field.
8 Optionally, enter a Location Name.
9 Click ResponseWare Connect.
A successful connection will appear as:
turningtechnologies.com/user-guides