Test Products International 460 User Manual
Page 36
7.
Press F1 (EXIT) to leave the Trigger menu, then ENTER. Now press Ch B. The following
menu should result.
8.
The previous screen shows the Channel B available selections. Click through the
sequence until you get to 1mV/Psi. Then finish the other selections and click ENTER. -
Check that the display shows Psi units at the top left of the screen. This is a spot check
on the sequence of one of the lists in this menu. You may choose to do this for the other
lists too (i.e.:ACA, DCA, etc.).
9.
Press ENTER to exit with your selections from the previous screen, the press Ch A. The
result should show the selections available specific to Channel A, as depicted in the
following screen.
dB measurement is available on ACV and DCV only.
dBV=20 log |V|, odBm=1mw
The result is displayed with the unit on alphanumeric display area of Figure 3-1.
460 User s Guide
Test and Calibration
A-4