SkyRC Hornet 60A ESC for Air - Manual (Page 8)

8
2. Program Card(Optional Part)
Program Card allows you to modify the most commonly used settings in
your HORNET ESC all at the touch of a single button. No computer needed.
Simply connect the Program Card to the throttle lead of the controller and
power the program card as described below. Click the button to scroll
through and change the indicated settings. All the settings will show on the
program card at once. Can't get any easier!
Turn off the ESC and disconnect the throttle lead from the receiver. Connect
the throttle lead from ESC to the 3 pin connector on the Program Card. Turn
on the ESC to apply power to both ESC and Program Card. All the current
settings will be displayed on the correspond LEDs.
Press and release button to move between settings. Press and hold button
to change the value for that setting.
Turn off the ESC and disconnect the throttle lead from Program Card.
Program Card
Connection Diagram
7. Start Level 1)Very Soft
Start
Governor mode: Softest start.
2)Soft
Start(D)*
Governor mode: Soft start, medium
spool up.
3)Fast Start
Governor mode: Faster start, fast spool
up
8. PWM
Switching Rate
1)12KHz(D)*
2)16KHz For low inductance motors.
3)24KHz For very low inductance motors.
4)Outrunner
Mode
Recommended for all outrunner motors.
Note: Factory Defaults are indicated by asterisk (D)*
For most brushless motors.