Rocktron Chameleon On-Line - Manual (Page 7)

4
3. Front Panel
1 POWER switch
2 RECALL button
This button is used to recall the displayed preset.
3 PRESET control
This control scrolls through the successive presets.
4 CONFIG button/led
The status of this button determines whether the Chameleon will display either the preset
number and title or the configuration of the currently displayed preset. The configuration
display indicates the effects that the displayed preset executes and, in most cases, the
order in which they are executed.
The LED above the CONFIG button is lit when the configuration is displayed.
5 DISPLAY panel
The DISPLAY panel provides 16 characters consisting of 14 segments each.
6 EFFECT BYPASS button/led
When lit, the Pre and Post effects are bypassed and only the Compressor/Preamp signal is
passed to the Chameleon outputs This button does not affect the condition of the Speaker
Simulator.
7 COMPARE button
The COMPARE button may be used to compare an altered parameter value to its stored
value.
This button may also be used to compare between the altered and stored values of multiple
parameters under the same function heading (i.e. "Reverb", "Mixer", etc.).
Note: If comparing an altered value to the stored value and the stored value is
currently being viewed, turning a knob or pressing a button that
changes the parameter value displayed will cancel the previous altered
value. This will also occur if a MIDI Control change is received while
viewing the stored value(s).