beautypg.com

Mossberg MMR User Manual

Page 20

background image

20

Remove your finger from the trigger. Rotate the safety selector lever fully to the

“OFF” (FIRE) position. The hammer should not release.

Leave the safety selector lever in the “OFF” (FIRE) position. Make certain

the firearm is pointed in a safe direction. Pull the trigger fully rearward.

THE

HAMMER SHOULD RELEASE.

When you have completed the function testing, open the action and rotate the

safety selector lever fully to the “ON” (SAFE) position.

IF YOUR FIREARM DOES NOT PERFORM AS DESCRIBED IN ANY

OF THE PREVIOUS STEPS, CONTACT THE FACTORY AUTHORIZED

PRODUCT SERVICE CENTER IMMEDIATELY. DO NOT ATTEMPT TO

USE THE FIREARM.

Firearms are complex mechanisms. Any modification, alteration, or

improper fitting of parts may result in a dangerous malfunction, damage to

the firearm, and injury to the shooter and/or others nearby. The firearm’s

owner must accept full responsibility for the correct reassembly and

functioning of the firearm after any disassembly or replacement of parts.

PERIODICALLY CHECK THAT THE MUZZLE BRAKE (IF SO EQUIPPED) IS

TIGHTENED FIRMLY ONTO THE BARREL.

SIGHT ADJUSTMENTS (OPTIONAL ON TACTICAL MODELS)

Before making any sight adjustments, open the action, remove the

magazine and visually and physically inspect the chamber and inside the

receiver to be certain the firearm is unloaded. Rotate the safety selector

lever fully to the “ON” (SAFE) position and keep the muzzle pointed in a

safe direction.

Elevation adjustment: To raise the point of impact, lower the front sight by

depressing the detent and turning the front sight clockwise. To lower the point of

impact, raise the front sight by depressing the detent and turning the front sight

counter-clockwise.

Fig. 55

Windage adjustment: To move the point of impact to the right, turn the side

adjustment knob clockwise into the “R”. To move the point of impact to the left,

turn the side adjustment knob counter-clockwise away from the “R”.

FRONT SIGHT POST

123161.indd 20

10/7/11 12:09 PM