Mossberg LB Lightning Bolt Action Trigger system adjustment - Manual

Your firearm may be equipped with Mossberg’s revolutionary “Lightning Bolt Action” Trig-
ger System (Patent Pending), an adjustable trigger system that allows you to safely ad-
just the trigger pull of your firearm from 2 to 7 pounds (approximately). Your firearm is
shipped with the trigger pull set at the factory minimum. You can
adjust the trigger pull by turning the Trigger Pull Adjusting Screw (See Figures 2-1, 2-2,
2-3, 2-4) clockwise (to increase trigger pull) or counterclockwise (to decrease trigger pull).
BEFORE ANY ATTEMPT IS MADE TO ADJUST YOUR TRIGGER PULL,
VISUALLY AND PHYSICALLY INSPECT THE CHAMBER AND MAGAZINE
TO MAKE SURE THAT YOUR FIREARM IS UNLOADED. KEEP THE
MUZZLE POINTED IN A SAFE DIRECTION AT ALL TIMES!!
To Adjust Your Trigger Pull
Remove the stock by removing the front and rear action screws. Lift the action out of the
stock. Adjust the trigger pull by turning the Trigger Pull Adjusting Screw clockwise (See
Figure 2-2) to increase trigger pull, or counterclockwise (See Figure 2-3) to decrease trig-
ger pull. The Trigger Pull Adjusting Screw incorporates a nylon patch that provides resist-
ance while turning the screw for adjustment. This is normal and to be expected. Do not
turn the Trigger Pull Adjusting Screw counterclockwise beyond flush with the trigger hous-
ing (See Figure 2-4). If the Trigger Pull Adjusting Screw protrudes beyond the surface of
the trigger housing, damage to the stock may occur during reassembly. Do not remove the
Trigger Pull Adjusting Screw or the Adjusting Spring from the trigger housing. The com-
ponents may get lost and trigger pull adjustment will not be possible. Reinstall the action
into the stock and tighten the front first, and then the rear, action screws. With your firearm
pointed in a safe direction, visually and physically inspect the chamber and magazine to
make sure that your firearm is unloaded. Then, using the instructions provided in this man-
ual, perform a complete function test (see the “Function Testing” section of your owner’s
manual). If the trigger pull is not to your satisfaction, repeat the above procedure until sat-
isfactory results are obtained.
No other trigger adjustments are provided. In order to avoid serious
personal injury to you or those around you, no other changes, alterations,
or adjustments should be made to the trigger system.
Firearms are complicated mechanisms. Any modification, alteration, or
improper fitting of parts may result in a dangerous malfunction, damage
to the firearm and injury to the shooter and other persons. The firearm’s
owner must accept full responsibility for the correct reassembly and
functioning of the firearm after any disassembly or replacement of parts.
LIGHTNING BOLT
ACTION (LBA)™
TRIGGER SYSTEM
ADJUSTMENTS
(if so equipped)
O.F. MOSSBERG & SONS, INC.
P.O. BOX 497 • 7 GRASSO AVENUE, NORTH HAVEN, CT 06473
PHONE (800) 363-3555
www.mossberg.com
Safety and safe firearms handling is everyone’s responsibility.