Martin Christ Gamma 2-16 LSCplus - Manual (Page 60)

Gamma 1-16 LSC&
Gamma 2-16 LSC&
6 Operation
60
Version 04/2013, Rev. 1.1 of 16/12/2013 • sb
Translation of the original operating manual
The unit will remain in the warm-up phase until you confirm.
The transition from "main drying" to "final drying" again takes place
automatically. After the completion of the "final drying" phase, the system
displays another enquiry with which the freeze-drying process will be
terminated. The unit remains in the "run" mode until the enquiry is
confirmed.
The process can be stopped any time by pressing the "Stop" button. In this
case, the unit will be switched to standby.
Pos: 137 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 138 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 60 Bet rieb/ LSCplus/ 060 -00 50- 002 2-0 010 Sollwert eing abe n im man uelle n Mo dus Lab or @ 6\m od_ 129 914 275 396 7_6 8.docx @ 3 670 3 @ 4 @ 1
6.5.2.1 Entering set values in the manual mode
The system has stored set values for every phase, and for every value
there are pre-defined value ranges that can be determined in the various
dialog boxes by pressing the buttons "min" and "max".
In order to protect the product, a safety pressure value can be entered in
every drying section.
Viewing or editing the set values:
• Press the button “Set values: view/edit” (see chapter 6.5.1.1 - "Main
window "Manual""). The following dialog box will be displayed:
1 "Aeration" button
2
"Defrosting" button
3 "Media drain" button
(special equipment)
4 "Leakage test" button
(option)
Fig. 54: Dialog box "Set values: view/edit"
Fields that are displayed in the form of buttons can be edited.
• Aeration (1)
If the freeze-dryer is equipped with an automatic aeration valve, this
button is used to define the aeration pressure.
• Defrosting (2)
This button is used to pre-define the defrosting time and temperature 1 .
In addition, this button is used to define whether the operating mode
“media drain” (see below) will be started automatically after the
defrosting process.
• Media drain (3)
If the freeze-dryer is equipped with an automatic media drain for
1 not for hot-water defrosting