Martin Christ Gamma 2-16 LSCplus - Manual (Page 34)

Gamma 1-16 LSC&
Gamma 2-16 LSC&
5 Set-up and connection
34
Version 04/2013, Rev. 1.1 of 16/12/2013 • sb
Translation of the original operating manual
Thyracont VSP62/63 MKS 722B Pfeiffer TPR 280/281
Fig. 16: Installed vacuum sensors of different manufacturers
NOTE
The vacuum sensor comes supplied in a calibrated state.
After the freeze-dryer has been switched on, the vacuum sensor needs
several minutes until it is ready for operation.
Pos: 101 /01 0 Univ ersal mod ule/ Lee rzeile @ 0\ mo d_12 021 162 445 00_ 0.doc x @ 1 14 @ @ 1
Pos: 102 /20 0 Ch rist/3 61 G T-BA L abo r-Pilot (PROJEKTE)/G am ma 1 -16 _2- 16 LSCplus/0 50 Au fstellu ng u nd Ansc hluss/ 050 -00 30 Bel üftun gsve ntil Ga mm a @ 1 5\m od_ 135 789 876 6560 _68 .docx @ 7 900 7 @ 2 @ 1
5.4 Aeration valve
The aeration valve is located on top of the left side of the unit (see chapter
2.1.1 - "Functional and operating elements").
After the end of a freeze-drying process, the unit will be aerated via the
aeration valve.
NOTE
The ice condenser chamber can be flooded with nitrogen via the hose
nozzle of the aeration valve.
WARNING
For the aeration with gases under pressure, the client must install a safety
device for pressure relief.
Pos: 103 /01 0 Univ ersal mod ule/ Sei tenwe chsel @ 0\ mod _12 021 1624 431 2_0 .docx @ 1 05 @ @ 1