Lumagen VisionProHDP - Manual (Page 8)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 5 Rev 1.1
User Commands
Power
Turn power on by pressing ON . Place the
VisionPro HDP
in standby-mode by pressing
STBY
.
Input Selection
The ten inputs are numbered from 1, … 9, 0. To select an input, press the respective
button (
1 to 0 ).
NOTE: To select an input, the menu must not be active.
Configuration Memory Selection
There are four configuration memories for each input. These are referred to as memory
“A,” “B,” “C,” and “D.” The first two are selected by pressing
MEMA , and MEMB ,
respectively. To select memory C, press
MENU
then
MEMA
. To select memory D, press
MENU then MEMB . Note, RS232 codes are provided to directly access MEMC and
MEMD .
When NTSC/PAL auto-selection is enabled (i.e. output mode set to AUTOIND ), MEMA
and MEMC are linked and used for NTSC and PAL, respectively. In this mode, if
MEMA or MEMC is active, an NTSC source automatically selects MEMA and a PAL
source automatically selects
MEMC
.
MEMB
and
MEMD
are also linked, with
MEMB
used for NTSC and
MEMD
for PAL.
Each configuration memory is independent of all others. To allow these memories to be
used for mode selection (e.g. day/night), the type remains unchanged when a new input is
selected. (e.g. if input 2 memory B is active pressing
3 selects input 3 memory B).
Input Aspect Ratio Selection
The four source aspect ratios are: 4:3, letterbox, 16:9, and 1.85. They can be selected by
pressing the
4:3 , LBOX , 16:9 , or 1.85 buttons, respectively. Use 4:3 for standard full-
screen material. Use LBOX for “letterbox” material, such as analog-television movies
shown with black bars above and below the image. For material labeled as “Enhanced for
16:9 televisions” selecting
16:9 is generally best. However, 1.85 can be used for sources
“Enhanced for 16:9 televisions” that have a 1.85 aspect ratio stretched vertically to 16:9.
The 4:3 input aspect ratio mode can also be programmed as a “non-linear stretch” mode
so 4:3 sources fill a 16:9 screen. See the Nonlinear Stretch section (page 20) for details.
Note:
Make sure the “television aspect ratio” setting is 16:9 in the setup menu of all source
devices that support this feature (e.g. DVD players), even if the screen is not 16:9.
Image Zoom
After the input aspect ratio has been selected, the image can be zoomed in to better fit the
screen. The zoom function uses the
‡
and
ˆ
arrow buttons. When the menu is off, the
‡
arrow button zooms in and the ˆ arrow button zooms out.