Lumagen VisionProHDP - Manual (Page 31)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 28 Rev 1.1
Menu tree
NOTE: When selecting among several options for a control, the active selection is highlighted in red.
MENU
→
IN
→
TYPE
→
Input type selection as appropriate for current input
DVI Digital-Video-Interface (HDMI compatible)
SDYPBPR Component using the SDTV color-space
HDYPBPR Component using the HDTV color-space
RGBHV RGB with separate Horizontal and vertical sync
RGBS RGB with separate composite sync
RGsB RGB with composite sync on green
VID Composite interlaced standard definition
SVID SVideo interlaced standard definition
SDI Serial Digital Interface
OUTSEL If output in INDEP mode , select one of 8 output configurations
CONFIG
→
COLR
→
BLCK Use display black for selected input
CONT Use display contrast for selected input
COLR
→
COLR Color saturation (Use “blue” color bar pattern)
HUE Hue (Use “blue” color bar pattern)
COLRED Red Color saturation offset (Use “red” color bar pattern)
HUERED Red Color Hue offset (Use “red” color bar pattern)
COLGRN Green Color saturation offset (Use “green” color bar pattern)
HUEGRN Green Hue offset (Use “green” color bar pattern)
CUE Chroma-Upsample-Error mitigation filter
CTMP Grayscale and gamma calibration (Service mode only)
ADJ
→
SIZE
→
TOPL Position top-left of input
BTMR Scale to position bottom-left corner of input
NLS Select 4:3 input as normal or Non-Linear-Stretch
SCALE Disable scaling if input resolution matches out resolution
YC-DLY Y/C delay independently for C
B
and C
R
SHARP Select image sharpness. Not available for most VisionDVI inputs
LEVL Analog black-pedestal or DVI-D levels
NAME Name input memory by following on-screen instructions
CNTRL
DEINT Deinterlacing control
MODE Select deinterlacing mode
FIELD Flip input fields (i.e. swap odd and even fields)
GENLCK Select genlock mode
DVI For DVI inputs, select modes
HDCP Select if DVI input reports HDCP capability
EDID Select EDID as Lumagen default, monitor values, or off
HOTPLUG Select if “hotplug” remains asserted when input not selected
COPY
→
ALL Copy current input memory to selected input memories
COLOR Copy the current input memory’s color parameters (only)