Lumagen VisionProHDP - Manual (Page 7)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 4 Rev 1.1
User Guide
This section describes the user interface for everyday functions. For initial setup
information see the Installer Guide section (page 6).
User commands can be entered with the supplied infrared remote control, or using the
RS232 serial control port. Contact the installer for information on user commands if the
RS232 serial port is used.
Remote Control
The infrared remote control is shown below.
Configuration
Memory
Selection
Input Aspect
Ratio Selection
Numeric
Entry and
Input
Selection
Power
Image
Zoom
Input Aspect
Ratio Selection
Step
Input Aspect
Ratio Selection
Step
Activate Menu
Exit/Cancel
Command completion
and OSD