Lumagen VisionProHDP - Manual (Page 29)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 26 Rev 1.1
Other Commands
Freeze frame
MENU 0 9 0 0
Freeze picture (RS232 code = ‘z’). Any button exits
S/W Rev
MENU 0 9 0 3
Display software revision, save-count and serial-number
Video/Film flag
MENU 0 9 1 8
Display input type on screen as video (V) or film (F)
Input Reselect
MENU 0 9 1 9
Ignore reselection of same input
TV Black
MENU 0 9 3 6
TV decoder black
TV Contrast
MENU 0 9 3 7
TV decoder contrast
TV MV Black
MENU 0 9 3 8
TV decoder Macrovision black offset
TV MV Contrast
MENU 0 9 3 9
TV decoder Macrovision contrast offset
In 3,4 sync level
MENU 0 9 4 4
Adjust sync-sense level for input 3 or 4
Saving the Configuration
Save
Note: If a save command is not executed, any changes will be lost when
the unit is put into standby power mode, or if power is interrupted.
Permanently save the current configuration. Note that, once saved, the configuration is
retained even if the unit is disconnected from power. Configuration from previous save is
retained to allow one-level of save-undo. The command format is:
MENU → SAVE → SAVE OK OK
Save Undo
Revert to the configuration over-written by the last save. Repeating the save undo
command toggles between the last two saved configurations.
The command format is:
MENU → SAVE → UNDO OK OK
Revert To Factory Settings
Sets all parameters to factory defaults. A SAVE is required to make permanent.
MENU 0 9 9 9
or
MENU → SAVE → FCTRY OK
Restore Configuration Saved during calibration
During calibration, the video technician can save the resulting Lumagen configuration to
a special hidden configuration memory. This command restores that configuration in the
event that the user inadvertently changes the configuration. A
SAVE is required to make
the restore permanent.
MENU → SAVE → RESTORE OK
Revert To Defaults For Current Output Resolution
Sets output parameters to defaults for the current output resolution. A SAVE is required to
make permanent.
MENU 0 9 9 8
or
MENU → SAVE → FCTRY OK