Lumagen VisionProHDP - Manual (Page 11)

VisionPro HDP
™ User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc. 8 Rev 1.1
Command Format
Commands are selected with the supplied infrared remote, or the RS232 serial port. To
prevent possible command conflict, only one of these should be used at a time.
The infrared remote control command notation is described below:
•
Remote buttons are named as shown on the remote in a bold font.
Example: MENU .
•
For comma separated lists, press the buttons in the sequence shown.
•
For parenthesized lists, select one button from the list.
•
For square-bracketed lists, press as needed.
Example: For the list [ … , † , ‡ , ˆ ], press the arrow keys as needed.
•
For menu commands press the MENU button. The ‡ , and ˆ arrow keys are used to
select the function. The † arrow key (or OK ) is used to enter sub-menus. This is
shown as: MENU → MenuItem → MenuItem. The … arrow key (or EXIT ) steps up one
menu level.
•
Numerical entries are listed as value . While entering the value, the … arrow key acts as
a backspace key.
•
Some commands are activated immediately. Other commands must be explicitly
accepted by pressing OK . If needed, OK is listed as part of the command.
•
Pressing
EXIT
cancels a partially completed command. If the menu system is active,
EXIT returns to one level higher in the menu system.
•
There are four independent configuration memory types for each input ( MEMA ,
MEMB , MEMC and MEMD ). The input setup and output resolution/timing can be set
independently for each memory. Note that, initially, there is a single output mode for
all configuration memories. To program an input memory, first select the input, then
select the desired configuration memory and use the menu system to configure.
•
Some menu commands are only available when their respective input is selected.
•
Before changes are saved, they can be discarded by entering standby mode.
•
To prevent unintended configuration changes, before saving, use the lock command.
•
Save the configuration after making changes, or changes will be lost when entering
STBY
mode.
If the serial port is used, the ASCII character associated with the respective remote
control button must be sent. See the Serial RS2323 Command Interface section (page 27)
for information on serial commands.