Lingenfelter L220160000 L220280000 Lingenfelter Magnuson Rear Jackshaft Bracket Kit v1.1 - Manual (Page 8)

Page
18. Using whatever method you choose, pull
the end of the jackshaft through the bearing.
Again, this operation should not take excessive
force to complete. As illustrated in the following
step, the end of the jackshaft should portrude out
of the bearing by roughly 1.1 inches.
19. The adjacent illustration shows the
jackshaft portruding from the bearing by 1.1000
inches.
20. Slide the front of the jackshaft into the
foward bearing housing. After lubricating the end
of the shaft, install the pulley hub onto the shaft.
Whatever method you use to install the pulley
hub, make sure that the hub stays square as you
tighten it, or else you may damage the hub.
7.
17. The adjacent illustration shows the snap
ring installed into the bearing housing.