Lingenfelter L220160000 L220280000 Lingenfelter Magnuson Rear Jackshaft Bracket Kit v1.1 - Manual (Page 3)

Page 2.
Additional Required Components
Optional Items
# Description Part number
2 3.00” 14 rib pulley L220180000
1 70mm 14 rib idler/tensioner pulley ATISK086H5
1 23.4” 14 rib belt K140234
2 3.25” 14 rib pulley L220190000
1 70mm 14 rib idler/tensioner pulley ATISK086H5
1 644mm 14 rib belt 14PK644
1 3.49” 14 rib pulley L220200000
1 3.25” 14 rib pulley L220190000
1 70mm 14 rib idler/tensioner pulley ATISK086H5
1 644mm 14 rib belt 14PK644
1 3.49” 14 rib pulley L220200000
1 3.00” 14 rib pulley L220180000
1 70mm 14 rib idler/tensioner pulley ATISK086H5
1 644mm 14 rib belt 14PK644
# Description Part number
2 Magnuson press-on 4 bolt hub (if needed) 69-00-87-010
1 TVS2300 Camaro carbon fiber jackshaft 52-02-18-168-CF
1 TVS2300 Corvette carbon fiber jackshaft 52-02-16-593-CF
Read the entire instruction manual before beginning installation. Some stock parts will
be used in reassembly.
When referencing the side of the vehicle, the driver side of the vehicle is considered the
left side and the passenger side of the vehicle is considered the right side of the vehicle.
The four (4) bolt hub must be pressed onto the supercharger shaft and the bearing must
be pressed into the bracket prior to installation of the new bracket assembly.
LPE is currently developing an installation tool to make the installation of the jackshaft
and rear pulley hub easier. This installation tool was used for the installation pictured in
this manual. Until the tool is released, the installer must come up with other means of
pressing the jackshaft into the bearing, as well as the rear pulley hub onto the jackshaft.
WARNING: When pressing the jackshaft out of the bearing, make sure that you are not
pressing against the entire rod as it can cause the carbon fiber jackshaft to fail.