Lingenfelter L220160000 L220280000 Lingenfelter Magnuson Rear Jackshaft Bracket Kit v1.1 - Manual (Page 10)

Page
26. Using a 6mm allen socket and blue
loctite, install the two (2) M10x1.5x30 flat head
countersunk bolts (PN: KP82415) that fasten the
tensioner bracket to the rear of the supercharger.
Torque the bolts to 35 ft-lbs.
27. Tighten the pulley hub against the end of
the jackshaft. The end of the jackshaft should be
flush with the outside of the pulley hub, as shown
in the picture.
28. If the MAP sensor was disconnected to
create added clearance earlier in this installation,
reconnect the MAP sensor at this time.
9.
25. The adjacent illustration shows the
tensioner pulley fastened to the tensioner bracket
by the T-nut from the front.