Lingenfelter L220160000 L220280000 Lingenfelter Magnuson Rear Jackshaft Bracket Kit v1.1 - Manual (Page 7)

Page
13. The adjacent illustration shows the LPE
supplied rear tensioner bracket and it’s bearing,
which will be installed in the following step. Make
sure to apply lubricant to the bearing before
attempting to press the bearing into the bracket.
14. Using an arbor press or equivalent, press
the new bearing into the new tensioner bracket
until some resistance is felt. This operation
should not take excessive force to complete.
WARNING: Make sure that you are pressing
on the outer race of the bearing, not the inner.
Pressing on the inner race of the bearing could
cause the bearing to fail
15. After pressing the bearing into the rear
tensioner bracket to the correct depth, the snap
ring groove inside the bearing housing should be
visible, as shown in the adjacent picture.
16. Using a pair of snap ring pliers, install the
supplied snap ring into the groove directly above
the bearing in the rear tensioner bracket bearing
housing.
6.