Labconco WaterPr BT Systems 90151 Series - Manual (Page 34)

Using the WaterPro® BT System
26
RO Water Using the Tank Outlet Valve
A
TANK OUTLET VALVE
• On a WaterPro® BT (UV) System: RO Water is obtained from the Tank
Outlet. Open the Tank Outlet Valve when RO Water is needed (A).
How to Dispense an Exact Amount of Product Water (F01)
1 Press the Main and “-“ Buttons
together to enter the menu. The
Display will show F01.
2 Press the “+” or “-“ Button to adjust
the exact amount of Product Water
(in Liters) needed. Pre-set volumes
of water can be adjusted from 0.25 L
to 9.75 L in 0.25 increments.
NOTE: The accuracy of this is
dependent upon the accuracy of the
Flow Calibration performed in
Section How to Calibrate the
Flowrate from the WaterPro® BT
System (F02).