Hydrating the system, Installation – Labconco WaterPr BT Systems 90151 Series User Manual
Page 24

16
Hydrating the System
•
At this time, the Final Filter is not installed. Leave the system
overnight or for several hours in FILLING TANK mode or PRE OPERATE
mode (see
Section Operating Modes
). The system will regularly
recirculate water and rinse off purification media inside the Filter
Pack cartridge. Do not leave the system in STANDBY mode.
•
(The next morning) Press the Dispensing Button once to put the
system into DISPENSING mode.
•
Allow about 1 Liter of water to be dispensed from the system.
•
Press the Dispensing Button once again. The system will finish
dispensing water.
•
Remove the Clear Tubing and the Barbed Fitting from the POU
Dispenser.
•
The Final Filter needs to be installed. See
This manual is related to the following products: