Labconco WaterPr BT Systems 90151 Series - Manual (Page 23)

Installation
15
Purging Air from the System
A • At this time you should have installed the Filter Pack cartridge,
Barbed Fitting and the Clear Tubing. Air trapped in the Filter Pack
cartridge should now be purged from the system.
• Verify that you have a full tank of RO water by viewing the Tank
Level display.
B • Press the Dispensing Button once to put the system into
DISPENSING mode.
C • Dispense water from the system to the 60% level (approximately
3.6L).
• The system will go into FILLING TANK mode when the tank level is
below the 60% level.
• When the tank level reaches the minimum level, the system will
finish dispensing water.