Konig Electronic USB turntable with speakers User Manual

Page 6

BASIC OPERATION

1. Connect the AC power cord to the AC outlet and the power indicator will illuminate.

2. Press the STANDBY button to turn the unit on.
3. Press the FUNCTION button repeatedly to select your desired source: PHONO, TUNER, USB or CARD.
4. Rotate the VOLUME knob to adjust the sound level.
5. Press the STANDBY button again to put the appliance on standby.
6. To completely switch off the appliance, you need to disconnect the power plug from the electrical outlet.
HOW TO SET THE TIME
Switch on the appliance first, and then press the STANDBY button to switch to standby mode.
1. Hold the MEMORY/MODE button, 24 HOUR will appear on the display. Press the ’ or ” button to

switch between 12 and 24 hour mode. Then press the MEMORY/MODE button to confirm the setting.

NOTE: If no operation is performed within approximately 10 seconds after you hold the MEMORY/MODE

button, the appliance will exit the time setting mode automatically and the setting is not memorized.

2. After you have set the 12/24 hour mode, hour digits will flash on the screen. Press the ’ or ” button

to set the hour. Press the MEMORY/MODE button again to confirm the setting, then minute digits will

flash on the screen. Press the ’ or ” button to adjust the minutes. After the minutes have been

adjusted, press the MEMORY/MODE button again to confirm the setting and exit the time setting mode.

NOTE: When setting in the 12 hour mode, ‘AM’ or ‘PM’ will also flash with the hour digits. Make sure the

time has been set correctly with an AM or PM indicator.

LINE OUT OPERATION

1. Plug one end of the LINE OUT cable (included) into the LINE OUT socket at the back of the unit.
2. Plug the other end of the cable into the LINE IN socket of your home amplifier device.
3. Switch on the unit.
4. Turn on the volume control if available.

LISTENING TO A RECORD

Cartridge

Stylus assembly

Getting started
Your turntable player can play 33, 45 & 78-RPM records
-- Remove the stylus protector first.
-- Turn the volume knob, which is located at the front of the unit, to adjust to your desired volume level.
-- Place a record (the record is not included) on the platter. Be sure not to handle the record with dirty

fingers. Never play a record that has a crack on the surface.

PLAYING A RECORD
Press the FUNCTION button to select PHONO (normally PHONO is the default function) and ‘PHONO’ will

appear on the display.